Edgework
EDGEWORK
There’s more than one way to get your glass edgework with Tecnoglass. You can choose from: Seamed, Polished and TecnoEdge.
Monolithic Glass
Type | Description | Glass Thickness | Finish | |
---|---|---|---|---|
Seamed | The Sharp edges of the glass are removed by a belt seamer. | ![]() ![]() |
1/8” – 5/16” | ![]() ![]() |
Flat Ground with Arris | This is a machine edge of flat form with a satin finish. | ![]() ![]() |
1/8” to 3/4” | ![]() ![]() |
Polished Ground with Arris | This is a machine edge of flat form with arrised edges which has been polished. | ![]() ![]() |
1/8” to 3/4” | ![]() ![]() |
Miltered Edges | This is a flat machined edge from a 1° to a 45°angle to the cut edge of the panel. The thickness of glass remaining at the edge is 1/16” (nominal). |
![]() ![]() |
1/4” – 3/4” | ![]() ![]() |
- Incorporating a mitered edge or silk-screened pattern must be approved before application.
- Laminated annealed glass can have ground, polished and mitered edges up to 2″ thickness.
- Tecnoglass recommends evaluating the aesthetics of ground, polished or mitered edges on heat-treated laminated glass because of the offset edges (edgework must be done prior to heat treating).
- The potential for mismatched edges can occur on glass up to 1/8″ in thickness.
Disclaimer – The information contained herein is exclusive property of Tecnoglass, who reserves the right to modify it, including but not limited to the designs and its specifications, without notice.